• 1-888-TEC-EASE
  • Outside USA: 1-716-785-6015
Tec-Ease Coupon GD&T Textbooks GD&T Training GD&T Public Seminars GD&T Computer Based Training GD&T Reference Material
Use Two Datum References for Angularity
(In accordance with Y14.5M-1994 standard)

PDF of this Tip

When setting up a part for the measurement of angularity on a sine bar, it is difficult to orient the part before performing the inspection.

This problem is overcome if a second datum is referenced in the angularity callout.

Back to Tips Tip added Feb 2000